Home › TRANSMISSION ยท A750F AUTOMATIC TRANSMISSION › VALVE BODY ASSEMBLY

VALVE BODY ASSEMBLY > INSTALLATION

for Preparation Click here



1. INSTALL TRANSMISSION VALVE BODY ASSEMBLY


D028696E01
  1. Insert the pin of the lever into the hole of the manual valve.

  1. Install 3 new drum seal gaskets onto the transmission case.



    D028694E02
  1. Install the 19 bolts.

    Torque:
    11 N*m{ 110 kgf*cm , 8 ft.*lbf }

    HINT:
    Each bolt length is indicated below.

    Bolt length:
    36 mm (1.42 in.) for bolt A
    25 mm (0.98 in.) for bolt B



2. CONNECT TRANSMISSION WIRE


D012704E03
  1. Connect the 7 connectors to the solenoid valves.

  1. Install the clamp with the 2 bolts.

    Torque:
    10 N*m{ 100 kgf*cm , 7 in.*lbf } for bolt A
    11 N*m{ 110 kgf*cm , 8 ft.*lbf } for bolt B

    HINT:
    Each bolt length is indicated below.

    Bolt length:
    12 mm (0.47 in.) for bolt A
    36 mm (1.42 in.) for bolt B

  1. Connect the ATF temperature sensor.



3. INSTALL VALVE BODY OIL STRAINER ASSEMBLY


D028692E01
  1. Install a new O-ring and the oil strainer with the 4 bolts.

    Torque:
    10 N*m{ 100 kgf*cm , 7 ft.*lbf }



4. INSTALL AUTOMATIC TRANSMISSION OIL PAN SUB-ASSEMBLY


C129385

HINT:
Remove the gasket and be careful not to spill oil on the contacting surfaces of the transmission case and oil pan.

  1. Install a new gasket and the oil pan with the 20 bolts.

    Torque:
    4.4 N*m{ 45 kgf*cm , 39 in.*lbf }



5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL


6. ADD AUTOMATIC TRANSMISSION FLUID
  1. Add automatic transmission fluid (Click here).



7. INSPECT AUTOMATIC TRANSMISSION FLUID
  1. Inspect the automatic transmission fluid (Click here).