Home › TRANSMISSION ยท A343F AUTOMATIC TRANSMISSION › TRANSMISSION CONTROL CABLE

TRANSMISSION CONTROL CABLE > ADJUSTMENT

for Preparation Click here



1. INSPECT SHIFT LEVER POSITION
  1. When moving the shift lever from P to R with the ignition switch ON and the brake pedal depressed, make sure that the shift lever moves smoothly and correctly into position.

  1. Start the engine and make sure that the vehicle moves forward after moving the shift lever from N to D, and moves rearward after shifting to R.
    If the results are not as specified, inspect the park/neutral position switch and adjust the shift lever position.



2. ADJUST SHIFT LEVER POSITION


G034515E01
  1. Move the shift lever to N.

  1. Remove the nut and disconnect the control cable.



    C236140E01
  1. Turn the control shaft lever clockwise until it stops, and then turn it counterclockwise 2 notches to set it to the N position.

  1. While holding the control shaft lever slightly toward the R position side, connect the cable with the nut.

    Torque:
    14 N*m{ 143 kgf*cm , 10 ft.*lbf }