Home › STEERING › POWER STEERING › VANE PUMP (for 1GR-FE)

VANE PUMP (for 1GR-FE) > INSTALLATION

for Preparation Click here



1. INSTALL VANE PUMP ASSEMBLY


    F051260E01
  1. Install the vane pump with the 2 bolts.

    Torque:
    21 N*m{ 214 kgf*cm , 15 ft.*lbf }



    F051259E02
  1. Install the wire harness clamp bracket with the bolt.

    Torque:
    8.0 N*m{ 82 kgf*cm , 71 in.*lbf }

  1. Connect the oil pressure switch connector.

    NOTICE:
    Make sure that no oil adheres to the connector.



2. CONNECT PRESSURE FEED TUBE ASSEMBLY
  1. Install a new gasket onto the pressure feed tube.



    C112619
  1. Install the pressure feed tube with the union bolt.

    Torque:
    49 N*m{ 500 kgf*cm , 36 ft.*lbf }



3. CONNECT OIL RESERVOIR TO PUMP HOSE


    F051257E01
  1. Connect the hose with the clip.



4. INSTALL FAN AND GENERATOR V BELT


    A076442E03
  1. While turning the belt tensioner counterclockwise, align its holes, and then insert a bar with a diameter of 6 mm (0.24 in.) into the holes to fix the belt tensioner.



  1. Install the V-ribbed belt.

    HINT:
    A113028E03
    If it is hard to install the V-ribbed belt, perform the following procedure.


    1. Put the V-ribbed belt on everything except the PS pump as shown in the illustration.

    2. While releasing the belt tension by turning the belt tensioner counterclockwise, put the V-ribbed belt on the PS pump.

  1. While turning the belt tensioner counterclockwise, remove the pin.



5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL


6. ADD POWER STEERING FLUID


7. BLEED AIR FROM POWER STEERING SYSTEM
(Click here)


8. CHECK POWER STEERING FLUID LEVEL IN RESERVOIR


9. CHECK FOR POWER STEERING FLUID LEAKAGE