DTC P0500 Vehicle Speed Sensor Malfunction |
| DTC Code | DTC Detection Condition | Trouble Area |
| P0500 | All conditions below are detected 500 times or more continuously (2-trip detection logic): (a) No signal from vehicle speed sensor (SPD1) is input to TCM while 48 pulses of speed sensor (SP2) signal are sent (b) Vehicle speed is 9 km/h (6 mph) or more for at least 4 seconds (c) PNP switch is off (shift lever not in P or N) |
|

| 1.READ VALUE USING INTELLIGENT TESTER (VEHICLE SPEED) |
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON.
Turn the intelligent tester on.
Enter the following menus: Powertrain / ECT / Data List.
Drive the vehicle.
Read the value displayed on the tester.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| Vehicle Speed | Vehicle speed/ Min.: 0 km/h (0 mph) Max.: 255 km/h (158 mph) | Actual vehicle speed | Speed indicated on speedometer |
|
| ||||
| OK | ||
| ||
| 2.CHECK COMBINATION METER ASSEMBLY (SPD1 SIGNAL WAVEFORM) |
![]() |
Remove the combination meter assembly with the connector(s) still connected.
Move the shift lever to N.
Jack up the vehicle.
Turn the ignition switch to ON.
Check the signal waveform according to the condition(s) in the table below.
| Terminal No. (Symbol) | Tool Setting | Condition |
| C27-6 - Body ground | 5 V/DIV., 20 msec./DIV. | Vehicle speed 20 km/h (12 mph) |
| *a | Component with harness connected (Combination Meter Assembly) |
|
| ||||
| OK | |
| 3.CHECK HARNESS AND CONNECTOR (COMBINATION METER ASSEMBLY - TCM) |
Disconnect the C27 combination meter assembly connector.
Disconnect the T37 TCM connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| C27-6 - T37-25 (SPD1) | Always | Below 1 Ω |
| C27-6 or T37-25 (SPD1) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | ||
| ||