DTC P2769 Torque Converter Clutch Solenoid Circuit Low (Shift Solenoid Valve SL) |
DTC P2770 Torque Converter Clutch Solenoid Circuit High (Shift Solenoid Valve SL) |
| DTC Code | DTC Detection Condition | Trouble Area |
| P2769 | ECM detects short in shift solenoid valve SL circuit (once) when shift solenoid valve SL is operated (1-trip detection logic) |
|
| P2770 | ECM detects open in shift solenoid valve SL circuit (once) when shift solenoid valve SL is not operated (1-trip detection logic) |
|

| 1.INSPECT TRANSMISSION WIRE (SHIFT SOLENOID VALVE SL) |
![]() |
Disconnect the E1 transmission wire connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| 7 (SL) - Body ground | 20°C (68°F) | 11 to 15 Ω |
| *a | Component without harness connected (Transmission Wire) |
|
| ||||
| OK | |
| 2.CHECK HARNESS AND CONNECTOR (SHIFT SOLENOID VALVE SL - ECM) |
![]() |
Disconnect the E10 ECM connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| E10-11 (SL) - Body ground | 20°C (68°F) | 11 to 15 Ω |
| *a | Rear view of wire harness connector (to ECM) |
|
| ||||
| OK | ||
| ||
| 3.INSPECT SHIFT SOLENOID VALVE SL |
![]() |
Remove shift solenoid valve SL.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| Shift solenoid valve SL connector terminal - Shift solenoid valve SL body | 20°C (68°F) | 11 to 15 Ω |
Apply 12 V battery voltage to the shift solenoid valve and check that the valve moves and makes an operating noise.
| Measurement Condition | Specified Condition |
| Valve moves and makes an operating noise |
| *a | Component without harness connected (Shift Solenoid Valve SL) |
|
| ||||
| OK | ||
| ||