Home › ENGINE ยท 1KD-FTV › STARTING › STARTER (for BOSCH Made)

STARTER (for BOSCH Made) > INSTALLATION

for Preparation Click here



1. INSTALL STARTER ASSEMBLY


    A201714E02
  1. Connect the ground cable and install the starter with the 2 bolts.

    HINT:
    Make sure to connect the ground cable with the bolt as shown in the illustration.

    Torque:
    68 N*m{ 693 kgf*cm , 50 ft.*lbf }



    A201713
  1. Install the starter wire to terminal 30 with the nut.

    Torque:
    9.8 N*m{ 100 kgf*cm , 87 in.*lbf }

  1. Connect the starter connector.



2. CONNECT CLUTCH RELEASE CYLINDER ASSEMBLY


G034223E01
  1. Install the release cylinder with the 2 bolts.

    Torque:
    12 N*m{ 120 kgf*cm , 9 ft.*lbf }



3. INSTALL FRONT FENDER SEAL
  1. Install the seal with the 5 clips.



4. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.