STARTER > INSPECTION |
| 1. INSPECT STARTER ASSEMBLY |

Perform pull-in test.
Remove the nut, and then disconnect the field coil lead wire from terminal C.
Connect the battery to the magnet starter switch as shown in the illustration. Then check that the clutch pinion gear moves outward.

Perform holding test.
When the battery is connected as above with the clutch pinion gear out, disconnect the negative (-) lead from terminal C. Check that the pinion gear remains out.

Inspect clutch pinion gear return.
Disconnect the negative (-) lead from the starter body. Check that the clutch pinion gear returns inward.

Perform operation test without load.
Connect the lead wire to terminal C with the nut.
Mount the starter in a vise between aluminum plates.
Connect the battery and an ammeter to the starter as shown in the illustration.
Check that the starter rotates smoothly and steadily while the pinion gear is moving outward. Then measure the current.

| 2. INSPECT STARTER ARMATURE ASSEMBLY |
Check the commutator for contamination and burns on its surface.
If the surface is dirty or burnt, correct it with sandpaper (No. 400) or a lathe.
Check the resistance.
![]() |
Measure the resistance between any 2 segments of the commutator.
![]() |
Measure the resistance between each segment of the commutator and armature coil core.
![]() |
Using a vernier caliper, measure the depth indicated in the illustration.
| 3. INSPECT STARTER COMMUTATOR END FRAME ASSEMBLY |
Check the brush length.
![]() |
Using a vernier caliper, measure the brush length.
Check the resistance.
![]() |
Measure the resistance between the positive (+) and negative (-) brushes.
| 4. INSPECT STARTER CENTER BEARING CLUTCH SUB-ASSEMBLY |
Check the gear teeth on the planet gears, internal gear and pinion gear of the starter center bearing clutch sub-assembly for wear or damage.
If any of the gears is damaged, replace the center bearing clutch sub-assembly.
![]() |
Hold the starter clutch and rotate the pinion gear clockwise and check that it turns freely. Try to rotate the pinion gear counterclockwise and check that it locks.
If the result is not as specified, replace the clutch sub-assembly.
| 5. INSPECT REPAIR SERVICE STARTER KIT |
![]() |
Check the plunger.
Push in the plunger and check that it returns quickly to its original position.
If the result is not as specified, replace the repair service starter kit.
Check the resistance.
![]() |
Measure the resistance between terminal 50 and terminal C.
![]() |
Measure the resistance between terminal 50 and the repair service starter kit body.