Home › ENGINE ยท 1KD-FTV › STARTING › STARTER (for DENSO Made)

STARTER (for DENSO Made) > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).



2. REMOVE FRONT FENDER SEAL
  1. Remove the 5 clips and seal.



3. REMOVE TRANSMISSION OIL FILLER TUBE SUB-ASSEMBLY
  1. Remove the oil dipstick.

  1. Remove the 2 bolts and transmission oil filter tube sub-assembly.

  1. Remove the O-ring from the transmission oil filter tube sub-assembly.



4. REMOVE STARTER ASSEMBLY


A111843
  1. Disconnect the starter connector.

  1. Open the terminal cap.

  1. Remove the nut and disconnect the starter wire.



    A122908
  1. Remove the 2 nuts, bolt, ground cable and starter.