Home › ENGINE ยท 1KD-FTV › STARTING › GLOW PLUG

GLOW PLUG > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.



2. REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY


    A111785
  1. Remove the 3 bolts, 2 nuts and engine cover.



3. REMOVE CHARGE AIR COOLER ASSEMBLY


    A111786
  1. Disconnect the IAT sensor connector.

  1. Disconnect the manifold absolute diesel pressure sensor connector.

  1. Disconnect the vacuum hose from the manifold absolute pressure sensor.



    A111787
  1. Loosen the 2 clamps.



    A112764
  1. Remove the 4 bolts and CAC.



4. REMOVE VACUUM SWITCHING VALVE BRACKET


    A110298
  1. Disconnect the 2 connectors.

  1. Disconnect the vacuum hoses from the 3 locations.

  1. Remove the 2 bolts and bracket.



5. REMOVE DIESEL THROTTLE BODY ASSEMBLY


    A111790
  1. Disconnect the throttle position sensor connector.

  1. Disconnect the throttle control motor connector.



    A111832
  1. Remove the 2 bolts, 2 nuts, throttle body and gasket.



6. REMOVE THROTTLE BODY BRACKET


    A110300
  1. Remove the 3 bolts and bracket.



7. REMOVE INTAKE AIR CONNECTOR
  1. Remove the 2 nuts, bolt, air connector and gasket.



8. REMOVE NO. 1 EGR PIPE SUB-ASSEMBLY


A099621E01
  1. Remove the 2 bolts, 2 nuts, pipe and 2 gaskets.



9. REMOVE EGR VALVE ASSEMBLY
  1. Remove the electric EGR control valve and gasket.



10. REMOVE NO. 1 GLOW PLUG CONNECTOR
  1. Remove the nut and wire harness.

  1. Remove the 4 screw grommets, 4 nuts and glow plug connector.



11. REMOVE GLOW PLUG ASSEMBLY


A111830
  1. Using a 12 mm deep socket wrench, remove the 4 glow plugs.