Home › ENGINE ยท 1KD-FTV › ENGINE CONTROL SYSTEM › ACCELERATOR PEDAL ROD

ACCELERATOR PEDAL ROD > INSTALLATION

for Preparation Click here



1. INSTALL ACCELERATOR PEDAL ROD ASSEMBLY


A098860E01

NOTICE:
  1. Be careful not to drop the accelerator pedal rod.
  2. Do not disassemble the accelerator pedal rod.
  3. This accelerator pedal does not require lubrication.
    Do not apply oil or lubricant to the accelerator pedal rod assembly.
    If applied, the accelerator pedal sensor assembly must be replaced.

  1. Install the pedal rod with the 2 bolts.

    Torque:
    5.0 N*m{ 51 kgf*cm , 44 in.*lbf }

  1. Connect the accelerator pedal position sensor connector.



2. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL