Home › ENGINE ยท 1KD-FTV › ENGINE CONTROL SYSTEM › ACCELERATOR PEDAL ROD

ACCELERATOR PEDAL ROD > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.



2. REMOVE ACCELERATOR PEDAL ROD ASSEMBLY


A098860E01

NOTICE:
  1. Be careful not to drop the accelerator pedal rod.
  2. Do not disassemble the accelerator pedal rod.
  3. This accelerator pedal does not require lubrication.
    Do not apply oil or lubricant to the accelerator pedal rod assembly.
    If applied, the accelerator pedal sensor assembly must be replaced.

  1. Disconnect the accelerator pedal position sensor connector.

  1. Remove the 2 bolts and pedal rod.