RADIATOR > INSTALLATION |
| 1. INSTALL RADIATOR ASSEMBLY |
Install the radiator with the 4 bolts.
Attach the 4 clamps to side of the radiator assembly.
Connect the 2 airbag sensor front connectors.
| 2. CONNECT OIL COOLER INLET HOSE (for Automatic Transmission) |
Connect the oil cooler inlet hose to the radiator assembly.
| 3. CONNECT OIL COOLER OUTLET HOSE (for Automatic Transmission) |
Connect the oil cooler outlet hose to the radiator assembly.
| 4. INSTALL FAN SHROUD |
Install the fan pulley to the water pump.
Place the fan shroud together with the fluid coupling fan between the radiator and engine.
Temporarily install the fluid coupling fan to the water pump with the 4 nuts. Tighten the nuts as much as possible by hand.
![]() |
Attach the claw of the shroud to the radiator assembly as shown in A in the illustration.
Install the fan shroud with the 2 bolts.
Connect the radiator reservoir hose to the radiator assembly.
Install the drive belt .
Tighten the 4 nuts of the fluid coupling fan.
| 5. INSTALL RADIATOR HOSE INLET |
| 6. INSTALL RADIATOR HOSE OUTLET |
| 7. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |
| 8. ADD ENGINE COOLANT |
Tighten all the plugs and fill the radiator with TOYOTA Super Long Life Coolant (SLLC).
| Item | Specified Condition |
| for Manual transmission | 7.8 liters (8.2 US qts, 6.9 Imp. qts) |
| for Automatic transmission | 8.1 liters (8.6 US qts, 7.1 Imp. qts) |
Fill the radiator with TOYOTA SLLC to the F line.
Press the inlet and outlet radiator hoses several times by hand, and then check the level of the coolant.
If the coolant level drops below the F line, add TOYOTA SLLC to the F line.
Install the radiator cap.
Bleed air from the cooling system.
Warm up the engine until the thermostat opens. While the thermostat is open, circulate the coolant for several minutes.
Maintain the engine speed at 2,500 to 3,000 rpm.
Press the inlet and outlet radiator hoses several times by hand to bleed air.
Stop the engine and wait until the coolant cools down to ambient temperature.
![]() |
Check the coolant level in the radiator reservoir.
If the coolant level is below the L line, add SLLC to the reservoir F line.
| 9. INSPECT FOR COOLANT LEAKS |
![]() |
Fill the radiator with coolant and attach a radiator cap tester.
Warm up the engine.
Using the radiator cap tester, increase the pressure inside the radiator to 118 kPa (1.2 kgf/cm2, 17.1 psi), and check that the pressure does not drop.
If the pressure drops, check the hoses, radiator and water pump for leaks. If no external leaks are found, check the cylinder block and head.
| 10. INSTALL RADIATOR SIDE DEFLECTOR LH |
Install the radiator side deflector LH with the 2 clips and attach the claw.
| 11. INSTALL RADIATOR SIDE DEFLECTOR RH |
Install the radiator side deflector RH with the 2 clips and attach the claw.
| 12. INSTALL RADIATOR GRILLE |
Attach the 6 claws to install the radiator grille.
Install the 2 screws and 2 clips.
| 13. INSTALL NO. 1 ENGINE UNDER COVER |
Install the No. 1 engine under cover with the 4 bolts.
| 14. PERFORM INITIALIZATION |
Perform initialization (Click here).