Home › ENGINE ยท 2TR-FE › COOLING › RADIATOR

RADIATOR > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag activation.



2. REMOVE RADIATOR GRILLE


    B277882
  1. Remove the 2 clips and 2 screws.



    B277883E01
  1. Put protective tape around the radiator grille.
    Text in Illustration 
    *1
    Protective Tape

  1. Detach the 6 claws and remove the radiator grille.



3. REMOVE RADIATOR SIDE DEFLECTOR LH


    A120283
  1. Using a clip remover, remove the 2 clips.

  1. Detach the claw and remove the deflector.



4. REMOVE RADIATOR SIDE DEFLECTOR RH
  1. Using a clip remover, remove the 2 clips.

  1. Detach the claw and remove the deflector.



5. REMOVE NO. 1 ENGINE UNDER COVER
  1. Remove the 4 bolts and cover.



6. DRAIN ENGINE COOLANT
  1. Remove the radiator cap.



  1. Loosen the cylinder block drain cock plug and radiator drain cock plug, and then drain the coolant.

    HINT:
    Collect the coolant in a container and dispose of it according to the regulations in your area.



    A112146E01



7. REMOVE RADIATOR HOSE INLET
  1. Remove the hose from the radiator tank upper and engine.



8. DISCONNECT RADIATOR HOSE OUTLET
  1. Disconnect the hose from the radiator tank lower.



9. REMOVE FAN SHROUD


A099963E02
  1. Disconnect the reservoir hose from the radiator tank upper.

  1. Loosen the 4 nuts holding the fluid coupling fan.

  1. Remove the drive belt (Click here).

  1. Remove the 2 bolts holding the fan shroud.

  1. Remove the 4 nuts holding the fluid coupling fan, and then remove the shroud together with the coupling fan.

    NOTICE:
    Be careful not to damage the radiator core.

  1. Remove the fan pulley from the water pump.



10. REMOVE RADIATOR ASSEMBLY


    A110375
  1. Disconnect the 2 front airbag sensor connectors.

  1. Using a clip remover, detach the 4 clamps shown in the illustration from the radiator side.

    HINT:
    Tape the clip remover tip before use.



    A099640E01
  1. Remove the 4 bolts and radiator.