Home › ENGINE ยท 2TR-FE › COOLING › RADIATOR

RADIATOR > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag activation.



2. REMOVE RADIATOR GRILLE


    B277882
  1. Remove the 2 clips and 2 screws.



    B277883E01
  1. Put protective tape around the radiator grille.
    Text in Illustration 
    *1
    Protective Tape

  1. Detach the 6 claws and remove the radiator grille.



3. REMOVE RADIATOR SIDE DEFLECTOR LH
  1. Using a clip remover, remove the 2 clips.

  1. Detach the claw and remove the radiator side deflector LH.



4. REMOVE RADIATOR SIDE DEFLECTOR RH
  1. Using a clip remover, remove the 2 clips.

  1. Detach the claw and remove the radiator side deflector RH.



5. REMOVE NO. 1 ENGINE UNDER COVER
  1. Remove the 4 bolts and No. 1 engine under cover.



6. DRAIN ENGINE COOLANT
  1. Remove the radiator cap.



  1. Loosen the cylinder block drain cock plug and radiator drain cock plug, and then drain the coolant.

    HINT:
    Collect the coolant in a container and dispose of it according to the regulations in your area.



    A112146E01



7. REMOVE RADIATOR HOSE INLET


8. REMOVE RADIATOR HOSE OUTLET


9. REMOVE FAN SHROUD


    A099963E02
  1. Disconnect the radiator reservoir hose from the radiator assembly.

  1. Loosen the 4 nuts holding the fluid coupling fan.

  1. Remove the drive belt .

  1. Remove the 2 bolts holding the fan shroud.

  1. Remove the 4 nuts of the fluid coupling fan, and then remove the fan shroud together with the fluid coupling fan.

    NOTICE:
    Be careful not to damage the radiator assembly.

  1. Remove the fan pulley from the water pump.



10. REMOVE OIL COOLER INLET HOSE
  1. Disconnect the oil cooler inlet hose from the radiator assembly.



11. REMOVE OIL COOLER OUTLET HOSE
  1. Disconnect the oil cooler outlet hose from the radiator assembly.



12. REMOVE RADIATOR ASSEMBLY
  1. Disconnect the 2 airbag sensor front connectors.



    A110375
  1. Using a clip remover, detach the 4 clamps from the side of radiator assembly as shown in the illustration.

    HINT:
    Tape the clip remover tip before use.



    A099640E01
  1. Remove the 4 bolts and radiator assembly.