WATER PUMP > INSTALLATION |
| 1. INSTALL WATER PUMP ASSEMBLY |
![]() |
Install a new gasket and the water pump with the 17 bolts.
| 2. INSTALL V-RIBBED BELT TENSIONER ASSEMBLY |
![]() |
Temporarily install the V-ribbed belt tensioner with the 5 bolts.
Install the V-ribbed belt tensioner by tightening bolt 1 and then bolt 2.
Tighten the other bolts.
| 3. INSTALL GENERATOR ASSEMBLY |
![]() |
Install the generator with the 2 bolts.
Install the generator wire with the nut and 2 bolts.
Install the terminal cap.
Connect the generator connector.
| 4. INSTALL NO. 2 IDLER PULLEY |

w/ Idler Pulley Cover Plate (PU107013ARMXY3):
![]() |
Install the idler pulley cover plate, idler pulley and No. 2 idler pulley cover plate with the bolt.
w/o Idler Pulley Cover Plate (PU107013ARMXY1):
![]() |
Install the idler pulley and No. 2 idler pulley cover plate with the bolt.
![]() |
for Integrated Type:
Install the 2 No. 2 idler pulleys with the 2 bolts.
| 5. INSTALL WATER INLET HOUSING |
![]() |
Install a new O-ring to the water outlet pipe.
Install a new O-ring to the water pump.
Apply soapy water to the O-rings.
![]() |
Install the water inlet with the 5 bolts.
![]() |
Connect the 3 water by-pass hoses.
| 6. CONNECT RADIATOR HOSE INLET |
| 7. CONNECT RADIATOR HOSE OUTLET |
| 8. INSTALL AIR CLEANER ASSEMBLY |
| 9. CONNECT NO. 2 VENTILATION HOSE |
| 10. INSTALL FAN SHROUD |
![]() |
Install the fan pulley to the water pump.
Place the shroud together with the fluid coupling fan between the radiator and engine.
Install the coupling fan to the water pump with 4 nuts. Tighten the nuts as much as possible by hand.
Attach the shroud's claws to the radiator as shown in the illustration.
Install the shroud with the 2 bolts.
Connect the reservoir hose to the radiator tank upper.
Install the drive belt .
Tighten the 4 nuts of the fluid coupling fan.
| 11. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |
| 12. ADD ENGINE COOLANT |
Tighten all the plugs and fill the radiator with TOYOTA Super Long Life Coolant (SLLC).
Fill the radiator reservoir with TOYOTA Super Long Life Coolant (SLLC) to the F line.
Install the radiator cap.
Bleed air from the cooling system.
Warm up the engine until the thermostat opens.
While the thermostat is open, circulate the coolant for several minutes.
Maintain the engine speed at 2,500 to 3,000 rpm.
Press the inlet and outlet radiator hoses several times by hand to bleed air.
Stop the engine and wait until the coolant cools down to ambient temperature.
![]() |
Check the coolant level in the radiator reservoir.
If the coolant level is below the L line, add SLLC to the reservoir F line.
| 13. CHECK FOR ENGINE COOLANT LEAKS |
Check for engine coolant leaks .
| 14. INSTALL V-BANK COVER |
| 15. INSTALL NO. 1 ENGINE UNDER COVER |
Install the under cover with the 4 bolts.