THERMOSTAT > INSTALLATION |
| 1. INSTALL WATER INLET HOUSING WITH THERMOSTAT |
![]() |
Install a new gasket to the water inlet housing with thermostat.
Install the water inlet housing with thermostat with the 3 nuts.
| 2. CONNECT RADIATOR HOSE OUTLET |
| 3. ADD ENGINE COOLANT |
Tighten all the plugs and fill the radiator with TOYOTA Super Long Life Coolant (SLLC).
Fill the radiator reservoir with TOYOTA Super Long Life Coolant (SLLC) to the F line.
Install the radiator cap.
Bleed air from the cooling system.
Warm up the engine until the thermostat opens.
While the thermostat is open, circulate the coolant for several minutes.
Maintain the engine speed at 2,500 to 3,000 rpm.
Press the inlet and outlet radiator hoses several times by hand to bleed air.
Stop the engine and wait until the coolant cools down to ambient temperature.
![]() |
Check the coolant level in the radiator reservoir.
If the coolant level is below the L line, add SLLC to the reservoir F line.
| 4. CHECK FOR ENGINE COOLANT LEAKS |
Check for engine coolant leaks .
| 5. INSTALL V-BANK COVER |
| 6. INSTALL NO. 1 ENGINE UNDER COVER |
Install the under cover with the 4 bolts.