Home › ENGINE ยท 1GR-FE › COOLING › RADIATOR

RADIATOR > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.



2. REMOVE NO. 1 ENGINE UNDER COVER
  1. Remove the 4 bolts and cover.



3. REMOVE RADIATOR GRILLE


    B277882
  1. Remove the 2 clips and 2 screws.



    B277883E01
  1. Put protective tape around the radiator grille.
    Text in Illustration 
    *1
    Protective Tape

  1. Detach the 6 claws and remove the radiator grille.



4. REMOVE RADIATOR SIDE DEFLECTOR LH


    A120283
  1. Using a clip remover, remove the 2 clips.

  1. Detach the claw and remove the deflector.



5. REMOVE RADIATOR SIDE DEFLECTOR RH
  1. Using a clip remover, remove the 2 clips.

  1. Detach the claw and remove the deflector.



6. DRAIN ENGINE COOLANT


  1. Remove the radiator cap.


    A110401E01

  1. Loosen the 2 cylinder block drain cock plugs and radiator drain cock plug, and then drain the coolant.

    HINT:
    Collect the coolant in a container and dispose of it according to the regulations in your area.



7. DISCONNECT RADIATOR HOSE INLET


8. DISCONNECT RADIATOR HOSE OUTLET


9. DISCONNECT NO. 1 OIL COOLER INLET TUBE
  1. Disconnect the inlet tube from the radiator tank lower.



10. DISCONNECT NO. 1 OIL COOLER OUTLET TUBE
  1. Disconnect the outlet tube from the radiator tank lower.



11. REMOVE FAN SHROUD


    A110406
  1. Remove the 3 bolts and oil reservoir.

  1. Disconnect the reservoir hose from the radiator tank upper.

  1. Loosen the 4 nuts holding the fluid coupling fan.

  1. Remove the drive belt .

  1. Remove the 2 bolts holding the fan shroud.

  1. Remove the 4 nuts holding the fluid coupling fan, and then remove the shroud together with the fluid coupling fan.

    NOTICE:
    Be careful not to damage the radiator core.

  1. Remove the fan pulley from the water pump.



12. REMOVE RADIATOR ASSEMBLY


    A112139
  1. Disconnect the 2 front airbag sensor connectors.

  1. Using a clip remover, detach the 4 clamps shown in the illustration from the radiator side.

    HINT:
    Tape the clip remover tip before use.



    A112140
  1. Remove the 4 bolts and radiator.