TIMING BELT > REMOVAL |
| 1. REMOVE NO. 1 ENGINE UNDER COVER |
| 2. DRAIN ENGINE COOLANT |
Loosen the radiator drain cock plug.
![]() |
Drain the coolant by removing the radiator reservoir cap and, using a wrench, remove the vent plug.
Loosen the cylinder block drain cock plug.

| *1 | Radiator Reservoir | *2 | Radiator Reservoir Cap |
| *3 | Vent Plug | *4 | Cylinder Block Drain Cock Plug |
| *5 | Radiator Drain Cock Plug | - | - |
| 3. REMOVE RADIATOR HOSE INLET |
| 4. REMOVE FAN SHROUD |
![]() |
Remove the 3 bolts and oil reservoir.
![]() |
Disconnect the No. 1 and No. 2 water by-pass hoses from the radiator.
Remove the 2 bolts and radiator reservoir.
Loosen the 4 nuts holding the fluid coupling with fan.
Remove the fan and generator V belt (Click here).
Remove the 2 bolts holding the fan shroud.
Remove the 4 nuts of the fluid coupling with fan, and then remove the fan shroud together with the fluid coupling with fan.
Remove the fan pulley from the water pump.
| 5. REMOVE NO. 1 TIMING BELT COVER |
![]() |
Remove the 6 bolts, 6 washers and timing belt cover.
| 6. REMOVE TIMING BELT |
![]() |
Turn the crankshaft clockwise and align the timing marks as shown in the illustration.
| *1 | Timing Mark |
![]() |
Uniformly loosen and remove the 2 bolts and No. 1 timing belt tensioner.
Remove the timing belt.
![]() |
| 7. REMOVE NO. 1 TIMING BELT IDLER SUB-ASSEMBLY |
Using a 10 mm hexagon wrench, remove the bolt, No. 1 timing belt idler and washer.