Home › ENGINE ยท 1KD-FTV › ENGINE MECHANICAL › ENGINE UNIT

ENGINE UNIT > REPLACEMENT

for Preparation Click here



1. REPLACE TIMING GEAR COVER OIL SEAL (for Supply Pump Gear)

HINT:
There are 2 methods to replace the oil seal.



  1. If the timing gear cover is removed from the cylinder block:



      A058117E01
    1. Using a screwdriver and hammer, tap out the oil seal.



    2. A058118E02
    3. Using SST and a hammer, tap in a new oil seal unit its surface is flush with the timing gear cover edge.

      SST
      09223-15020  
      09502-12010  
      09950-70010   (09951-07100)

    4. Apply MP grease to the lip of the oil seal.



  1. If the timing gear cover is installed to the cylinder block:



      A058126E01
    1. Using a knife, cut through the lip of the oil seal.

    2. Using a screwdriver, pry out the oil seal.

      NOTICE:
      Be careful not to damage the crankshaft.

    3. Apply MP grease to the lip of a new oil seal.



    4. A058127E01
    5. Using SST and a hammer, tap in the oil seal until its surface is flush with the timing gear cover edge.

      SST
      09223-15020  
      09502-12010  
      09950-70010   (09951-07100)



2. REPLACE TIMING GEAR COVER OIL SEAL (for Crankshaft)

HINT:
There are 2 methods to replace the oil seal.



  1. If the timing gear cover is removed from the cylinder block:



      A058121E01
    1. Using a screwdriver and hammer, tap out the oil seal.



    2. A058119E01
    3. Using SST and a hammer, tap in a new oil seal until its surface is flush with the timing gear cover edge.

      SST
      09214-76011  

    4. Apply MP grease to the lip of the oil seal.



  1. If the timing gear cover is installed to the cylinder block:



      A058124E01
    1. Using SST, remove the oil seal.

      SST
      09308-10010  
      09950-40011   (09957-04010)
      09950-60010   (09951-00350)

    2. Apply MP grease to the lip of a new oil seal.



    3. A058125E01
    4. Using SST and a hammer, tap in the oil seal until its surface is flush with the timing gear cover edge.

      SST
      09214-76011  



3. REPLACE REAR ENGINE OIL SEAL


    A061819E01
  1. Using a screwdriver and hammer, tap out the oil seal.



    A253830E01
  1. Using SST and a hammer, tap in a new oil seal until its surface is flush with the rear oil seal retainer edge.

    SST
    09518-36030  
    09950-70010   (09951-07100)

  1. Apply MP grease to the lip of the oil seal.