ENGINE UNIT > REPLACEMENT |
| 1. REPLACE CYLINDER BLOCK TIGHT PLUG |
Remove the tight plugs.
Apply adhesive to new tight plugs.
Position A:
Using a 14 mm steel bar and hammer, tap in the tight plug as shown in the illustration.
Other positions:
Using SST and a hammer, tap in the tight plugs as shown in the illustration.
Position B

| *1 | Stops | - | - |
| *a | Right Side | *b | Left Side |
| *c | Front Side | *d | Rear Side |
| 2. REPLACE STRAIGHT PIN |
Remove the straight pins.
Using a plastic-faced hammer, tap in new straight pins to the cylinder block.
| Item | Specified Condition |
| Pin A | 7.5 mm (0.295 in.) or less |
| Pin B | 6 mm (0.234 in.) or less |
| Pin C | 12 mm (0.472 in.) or less |

| *1 | Pin A | *2 | Pin B |
| *3 | Pin C | *4 | Protrusion height |
| *a | Front Side | *b | Rear Side |
| 3. REPLACE RING PIN |
Remove the ring pins.
Using a plastic-faced hammer, tap in new ring pins to the cylinder block.

| *a | Cylinder Head Side | *b | 6 mm (0.236 in.) or less |
| 4. REPLACE TURBO WATER HOSE UNION |
Remove the turbo water hose union from the cylinder block.
Clean the cylinder block side hole and new turbo water hose union with non-residue solvent.
![]() |
Apply adhesive onto the shaded area of a turbo water hose union as shown in the illustration.
| *a | Front |
| *b | 5.0 mm (0.197 in.) |
| *c | 2.0 mm (0.787 in.) |
| *d | Adhesive |
Set the turbo water hose union and tap it until the edge of the turbo water hose union fits against the chamfered part of the cylinder block as shown in the illustration.