Home › BODY ELECTRICAL › LIGHTING › IGNITION KEY CYLINDER LIGHT

IGNITION KEY CYLINDER LIGHT > INSTALLATION

for Preparation Click here



1. INSTALL KEY CYLINDER LIGHT ASSEMBLY


    E226243
  1. Connect the connector.

  1. Push in the key cylinder light assembly in the direction indicated by the arrow in the illustration to install it.



2. INSTALL STEERING COLUMN COVER UPPER
  1. Attach the claw to install the upper cover.



3. INSTALL STEERING COLUMN COVER LOWER


    C238860
  1. Install the lower cover with the 3 screws.



4. INSTALL STEERING WHEEL ASSEMBLY


    G100880E01
  1. Align the matchmarks on the steering wheel and main shaft.

  1. Install the steering set nut.

    Torque:
    50 N*m{ 510 kgf*cm , 37 ft.*lbf }



5. PLACE FRONT WHEELS FACING STRAIGHT AHEAD


6. INSPECT STEERING WHEEL CENTER POINT


7. INSTALL STEERING PAD ASSEMBLY
(Click here)


8. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL


9. INSPECT STEERING PAD ASSEMBLY
  1. With the steering pad installed on the vehicle, perform a visual check. If there are any defects as mentioned below, replace the steering pad with a new one:
    Cuts, minute cracks or marked discoloration on the steering pad top surface or in the grooved portion.

  1. Make sure that the horn sounds.
    If the horn does not sound, inspect the horn system.



10. CHECK SRS WARNING LIGHT
  1. Check the SRS warning light (Click here).