Home › BODY ELECTRICAL › LIGHTING › IGNITION KEY CYLINDER LIGHT

IGNITION KEY CYLINDER LIGHT > INSTALLATION

for Preparation Click here



1. INSTALL KEY CYLINDER LIGHT ASSEMBLY


    E226243
  1. Connect the connector.

  1. Push in the key cylinder light assembly in the direction indicated by the arrow in the illustration to install it.



2. INSTALL STEERING COLUMN COVER UPPER
  1. Attach the claw to install the upper cover.



3. INSTALL STEERING COLUMN COVER LOWER


    C238860
  1. Install the lower cover with the 3 screws.



4. INSTALL STEERING WHEEL ASSEMBLY


    G100880E01
  1. Align the matchmarks on the steering wheel and main shaft.

  1. Install the steering set nut.

    Torque:
    50 N*m{ 510 kgf*cm , 37 ft.*lbf }



5. PLACE FRONT WHEELS FACING STRAIGHT AHEAD


6. INSPECT STEERING WHEEL CENTER POINT


7. INSTALL STEERING PAD ASSEMBLY
(Click here)


8. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL


9. INSPECT STEERING PAD ASSEMBLY


    B278764
  1. Support the steering pad with one hand.

  1. Connect the connector to the steering pad.

    NOTICE:
    When handling the airbag connector, do not damage the airbag wire harness.

  1. Connect the horn connector.

  1. Confirm that the groove along the circumference of the "TORX" screw is attached to the screw case and place the steering pad onto the steering wheel.

  1. Using a T30 "TORX" socket wrench, tighten the 2 screws.

    Torque:
    8.8 N*m{ 90 kgf*cm , 78 in.*lbf }



10. CHECK SRS WARNING LIGHT
  1. Check the SRS warning light (Click here).