Home › ENGINE ยท 5L-E › STARTING › STARTER

STARTER > DISASSEMBLY

for Preparation Click here



1. REMOVE STARTER YOKE ASSEMBLY
  1. Remove the screw and terminal 50 wire.



    B000461E01
  1. Remove the nut and disconnect the terminal C wire.

  1. Remove the 2 screws and O-rings, and pull out the starter yoke assembly with the armature assembly.



2. REMOVE MAGNET STARTER SWITCH ASSEMBLY


    B000465E01
  1. Remove the 2 screws and magnet starter switch.

  1. Remove the return spring.



    B000464E01
  1. Remove the following parts from the starter housing.
    (1)
    Starter clutch
    (2)
    Starter armature pinion
    (3)
    Starter idler pinion
    (4)
    Retainer
    (5)
    Clutch roller



    P005056E01
  1. Using a magnetic finger, remove the steel ball.



3. REMOVE STARTER BRUSH HOLDER ASSEMBLY


    N000562E01
  1. Using a screwdriver, hold the spring back and disconnect the brush.

  1. Disconnect the 4 brushes and remove the brush holder.



4. REMOVE STARTER ARMATURE ASSEMBLY


    P005488E01
  1. Using a plastic-faced hammer, tap the end of the starter yoke and remove the armature.