Home › ENGINE ยท 5L-E › CHARGING › GENERATOR

GENERATOR > REASSEMBLY

for Preparation Click here



1. INSTALL GENERATOR ROTOR ASSEMBLY
  1. Using a press, press in the rotor.

  1. Place the washer on the rotor.



2. INSTALL GENERATOR RECTIFIER END FRAME


    S003959E02
  1. Using a 17 mm socket wrench and press, slowly press in the rectifier end frame.



    A074011E03
  1. Install the cord clamp and 4 nuts.

    Torque:
    5.9 N*m{ 60 kgf*cm , 53 in.*lbf }



3. INSTALL GENERATOR HOLDER WITH RECTIFIER


    A074013E02
  1. Install the 4 rubber insulators on the lead wires.

    NOTICE:
    Be careful to install the rubber insulators in the correct direction.



    A074014E02
  1. While pushing down on the rectifier holder, install it with the 4 screws.

    Torque:
    2.9 N*m{ 30 kgf*cm , 26 in.*lbf }



4. INSTALL BRUSH HOLDER AND REGULATOR


    A074015E01
  1. Install the regulator with the 3 screws.

    Torque:
    2.0 N*m{ 20 kgf*cm , 18 in.*lbf }

  1. Install the seal plate.

  1. Install the brush holder with the 2 screws.

    Torque:
    2.0 N*m{ 20 kgf*cm , 18 in.*lbf }

  1. Install the brush holder cover.



5. INSTALL GENERATOR REAR END COVER


    A074016E02
  1. Install the rear end cover and plate terminal with the bolt and 3 nuts.

    Torque:
    4.4 N*m{ 45 kgf*cm , 39 in.*lbf } for nut
    3.9 N*m{ 40 kgf*cm , 35 in.*lbf } for bolt

  1. Install the terminal insulator with the nut.

    Torque:
    4.1 N*m{ 42 kgf*cm , 36 in.*lbf }



6. INSTALL VACUUM PUMP ASSEMBLY
  1. Align the matchmarks and install the vacuum pump with the 4 bolts.

    Torque:
    7.8 N*m{ 80 kgf*cm , 69 in.*lbf }