Home › ENGINE ยท 1GR-FE › EMISSION CONTROL › PCV VALVE

PCV VALVE > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.



2. REMOVE V-BANK COVER
  1. Remove the 2 nuts and cover.



3. REMOVE INTAKE AIR SURGE TANK


    A075597E01
  1. Disconnect the No. 5 water by-pass hose.



    A075598E01
  1. Disconnect the No. 4 water by-pass hose.



    A075644E01
  1. Disconnect the purge line hose.



    A075645E01
  1. Disconnect the No. 1 ventilation hose.



    A075646E01
  1. Disconnect the purge VSV connector.

  1. Disconnect the VSV connector (for ACIS).

  1. Disconnect the throttle position sensor and control motor connector.

  1. Remove the 3 wire harness clamps and hose clamp.



    A075647E01
  1. Remove the 3 upper bolts which are used to secure the 2 surge tank stays and throttle body bracket.



    A075648E03
  1. Using an 8 mm hexagon wrench, remove the 4 bolts.

  1. Remove the 2 nuts, intake air surge tank and gasket.



4. REMOVE VENTILATION VALVE SUB-ASSEMBLY


A112001
  1. Loosen the hose clamp and disconnect the ventilation hose from the valve.

  1. Remove the valve.