Home › BODY ELECTRICAL › LIGHTING › HEADLIGHT DIMMER SWITCH

HEADLIGHT DIMMER SWITCH > INSTALLATION

for Preparation Click here



1. INSTALL HEADLIGHT DIMMER SWITCH ASSEMBLY


    B113204
  1. Install the headlight dimmer switch with the claw as shown in the illustration.



    B113203
  1. Install the headlight dimmer switch with the clamp.



    B117649
  1. Connect the connector.



2. INSTALL WIPER AND WASHER SWITCH ASSEMBLY
  1. Attach the claw to install the windshield wiper switch.

    NOTICE:
    Do not push the claw with excessive force as damage may occur.

  1. Connect the connectors.



3. INSTALL SPIRAL CABLE SUB-ASSEMBLY
  1. Check that the front wheels are facing straight ahead.

  1. Set the turn signal switch to the neutral position.

    NOTICE:
    Make sure that the turn signal switch is in the neutral position, as the pin of the turn signal switch may be snapped.

  1. Install the spiral cable.

    NOTICE:
    When replacing the spiral cable with a new one, remove the lock pin before installing the steering wheel.

  1. Connect the connectors to the spiral cable.

    NOTICE:
    When handling the airbag connector, do not damage the airbag wire harness.



4. INSTALL STEERING COLUMN COVER UPPER
  1. Attach the claw to install the upper cover.



5. INSTALL STEERING COLUMN COVER LOWER


    C238860
  1. Install the lower cover with the 3 screws.



6. INSTALL STEERING WHEEL ASSEMBLY


    G100880E01
  1. Align the matchmarks on the steering wheel and main shaft.

  1. Install the steering set nut.

    Torque:
    50 N*m{ 510 kgf*cm , 37 ft.*lbf }



7. PLACE FRONT WHEELS FACING STRAIGHT AHEAD


8. INSPECT STEERING WHEEL CENTER POINT


9. INSTALL STEERING PAD ASSEMBLY
(Click here)


10. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL


11. INSPECT STEERING PAD ASSEMBLY
  1. With the steering pad installed on the vehicle, perform a visual check. If there are any defects as mentioned below, replace the steering pad with a new one:
    Cuts, minute cracks or marked discoloration on the steering pad top surface or in the grooved portion.

  1. Make sure that the horn sounds.
    If the horn does not sound, inspect the horn system.



12. CHECK SRS WARNING LIGHT
  1. Check the SRS warning light (Click here).