Home › BODY ELECTRICAL › LIGHTING › HEADLIGHT DIMMER SWITCH

HEADLIGHT DIMMER SWITCH > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.



2. PLACE FRONT WHEELS FACING STRAIGHT AHEAD


3. REMOVE STEERING PAD ASSEMBLY
(Click here)


4. REMOVE STEERING WHEEL ASSEMBLY
  1. Remove the steering wheel set nut.



    G034428E02
  1. Place matchmarks on the steering wheel and main shaft.

  1. Using SST, remove the steering wheel.

    SST
    09950-50013   (09951-05010, 09952-05010, 09953-05020, 09954-05021)



5. REMOVE STEERING COLUMN COVER LOWER


    C238860
  1. Remove the 3 screws and lower cover.



6. REMOVE STEERING COLUMN COVER UPPER
  1. Detach the claw and remove the upper cover.



7. REMOVE SPIRAL CABLE SUB-ASSEMBLY


B110259E02
  1. Disconnect the connectors from the spiral cable.

    NOTICE:
    When handling the airbag connector, do not damage the airbag wire harness.

  1. Detach the 3 claws and remove the spiral cable.



8. REMOVE WIPER AND WASHER SWITCH ASSEMBLY


    E225945
  1. Disconnect the connectors.

  1. Detach the claw and remove the windshield wiper switch.

    NOTICE:
    Do not push the claw with excessive force as damage may occur.



9. REMOVE HEADLIGHT DIMMER SWITCH ASSEMBLY


    B117649
  1. Disconnect the connector.



    B113202
  1. Using needle-nose pliers, remove the band clamp as shown in the illustration.



    B085631E03
  1. Using a screwdriver, detach the claw and remove the switch.

    HINT:
    Tape the screwdriver tip before use.