Home › BODY ELECTRICAL › LIGHTING › HAZARD WARNING SWITCH

HAZARD WARNING SWITCH > REMOVAL

for Preparation Click here


HINT:
  1. Use the same procedures for the RH and LH sides.
  2. The procedures listed below are for the LH side.



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.



2. REMOVE INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY CENTER


B278367E01


  1. for Manual Air Conditioning System:

    1. Put protective tape around the center instrument cluster finish panel.
      Text in Illustration 
      *1
      Protective Tape

    2. Using a moulding remover, detach the 10 claws and 4 clips.



    3. B278366
    4. Detach the 4 claws and disconnect the air conditioner control.

    5. Disconnect the connectors and remove the center instrument cluster finish panel.



    B278368E01
  1. for Automatic Air Conditioning System:

    1. Put protective tape around the center instrument cluster finish panel.
      Text in Illustration 
      *1
      Protective Tape

    2. Using a moulding remover, detach the 8 claws and 4 clips.

    3. Disconnect the connectors and remove the center instrument cluster finish panel.



3. REMOVE HEATER CONTROL KNOB


E225817
  1. Remove the heater control knob as shown in the illustration.



4. REMOVE FRE/REC CONTROL KNOB


E225816
  1. Remove the No. 2 heater control knob as shown in the illustration.



5. REMOVE HAZARD WARNING SIGNAL SWITCH ASSEMBLY


    B113570E01
  1. Detach the 2 claws and remove the switch.