Home › BODY › WINDSHIELD / WINDOWGLASS › POWER WINDOW REGULATOR MOTOR

POWER WINDOW REGULATOR MOTOR > INSPECTION

for Preparation Click here


HINT:
  1. Use the same procedure for RHD and LHD vehicles.
  2. The procedure listed below is for LHD vehicles.



1. INSPECT POWER WINDOW REGULATOR MOTOR ASSEMBLY (for Front LH, w/Regulator)


B285951E01
  1. Apply battery voltage to connector terminals 1 and 2.

    NOTICE:
    Do not apply battery voltage to any terminals except terminals 1 and 2.

  1. Check that the motor gear rotates smoothly as follows.

    OK:
    Measurement Condition
    Specified Condition
    Battery positive (+) → 2
    Battery negative (-) → 1
    Arm of window regulator rotates clockwise (Up)
    Battery positive (+) → 1
    Battery negative (-) → 2
    Arm of window regulator rotates counterclockwise (Down)

    1. If the result is not as specified, replace the front door window regulator sub-assembly.



2. INSPECT POWER WINDOW REGULATOR MOTOR ASSEMBLY (for Front RH, w/Regulator)


B285952E01
  1. Apply battery voltage to connector terminals 1 and 2.

    NOTICE:
    Do not apply battery voltage to any terminals except terminals 1 and 2.

  1. Check that the motor gear rotates smoothly as follows.

    OK:
    Measurement Condition
    Specified Condition
    Battery positive (+) → 2
    Battery negative (-) → 1
    Arm of window regulator rotates counterclockwise (Up)
    Battery positive (+) → 1
    Battery negative (-) → 2
    Arm of window regulator rotates clockwise (Down)

    1. If the result is not as specified, replace the front door window regulator sub-assembly.



3. INSPECT POWER WINDOW REGULATOR MOTOR ASSEMBLY (for Rear LH, w/Regulator)


B285953E01
  1. Apply battery voltage to connector terminals 1 and 2.

  1. Check that the motor gear rotates smoothly as follows.

    OK:
    Measurement Condition
    Specified Condition
    Battery positive (+) → 2
    Battery negative (-) → 1
    Arm of window regulator rotates clockwise (Up)
    Battery positive (+) → 2
    Battery negative (-) → 1
    Arm of window regulator rotates counterclockwise (Down)

    1. If the result is not as specified, replace the rear door window regulator sub-assembly.



4. INSPECT POWER WINDOW REGULATOR MOTOR ASSEMBLY (for Rear RH, w/Regulator)


B285954E01
  1. Apply battery voltage to connector terminals 1 and 2.

  1. Check that the motor gear rotates smoothly as follows.

    OK:
    Measurement Condition
    Specified Condition
    Battery positive (+) → 2
    Battery negative (-) → 1
    Arm of window regulator rotates counterclockwise (Up)
    Battery positive (+) → 1
    Battery negative (-) → 2
    Arm of window regulator rotates clockwise (Down)

    1. If the result is not as specified, replace the rear door window regulator sub-assembly.