Home › BODY ELECTRICAL › OTHER SYSTEM › POWER OUTLET SOCKET

POWER OUTLET SOCKET > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.



2. REMOVE SWITCH BASE


B278245
  1. Detach the 9 claws and guide.

    HINT:
    If the claws are difficult to detach, detach the claws from the back of the switch base.

  1. Disconnect the connectors and remove the switch base.



3. REMOVE NO. 1 POWER OUTLET SOCKET ASSEMBLY


E003722
  1. Rotate the socket to disengage the notch.



    B108949
  1. Pull out the socket halfway and rotate the socket until its protrusion is aligned with the groove of the cover.

  1. Remove the socket from the cover.



4. REMOVE BACK DOOR SCUFF PLATE


B276933
  1. Detach the 4 claws, 2 guides and 6 clips and remove the back door scuff plate.



5. REMOVE REAR DOOR SCUFF PLATE LH


B276927E01
  1. Put protective tape around the rear door scuff plate.
    Text in Illustration 
    *1
    Protective Tape

  1. Using a moulding remover, detach the 7 claws and 2 clips and remove the rear door scuff plate.



6. REMOVE REAR DOOR OPENING TRIM WEATHERSTRIP LH


B276955
  1. Remove the rear door opening trim weatherstrip.



7. REMOVE QUARTER TRIM HOOK


B276937

HINT:
Use the same procedure for both quarter trim hooks.

  1. Remove the screw and quarter trim hook.



8. REMOVE QUARTER INSIDE TRIM BOARD LH


B277799
  1. Detach the 2 claws and remove the outer lap belt anchor cover.

    HINT:
    Use the same procedure for both outer lap belt anchor covers.



    B277800
  1. Remove the bolt and disconnect the rear No. 1 seat outer belt floor anchor.



    B277801
  1. Remove the bolt and disconnect the rear No. 2 seat outer belt floor anchor.

  1. Using a clip remover, remove the clip.

  1. Detach the 7 claws and 10 clips.



  1. Disconnect the power point socket connector and remove the quarter inside trim board.


    B276940



9. REMOVE REAR NO. 1 POWER OUTLET SOCKET ASSEMBLY


B118562E01
  1. Detach the 2 claw fittings and remove the socket.