Home › ENGINE · 5L-E › STARTING › GLOW RELAY

GLOW RELAY > ON-VEHICLE INSPECTION

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag activation.



2. REMOVE GLOW RELAY
  1. Remove the engine room relay block cover.

  1. Remove the glow relay from the engine room relay block.



3. INSPECT GLOW RELAY


    A111813E03
  1. Measure the resistance of the glow relay.

    Standard resistance:
    Tester Connection
    Specified Condition
    3 - 5
    10 kΩ or higher
    3 - 5
    Below 1 Ω
    (when battery voltage is applied to terminals 1 and 2)

    If the result is not as specified, replace the relay.



4. INSTALL GLOW RELAY


5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL