Home › ENGINE ยท 1GR-FE › ENGINE MECHANICAL › ENGINE ASSEMBLY

ENGINE ASSEMBLY > INSPECTION

for Preparation Click here



1. INSPECT INTAKE MANIFOLD


    A076807E04
  1. Using a precision straightedge and feeler gauge, measure the warpage of the contact surface of the cylinder head and intake air surge tank.

    Maximum warpage:
    Item
    Specified Condition
    Intake manifold side
    0.8 mm (0.031 in.)
    Cylinder head side
    0.2 mm (0.008 in.)

    If the warpage is greater than the maximum, replace the intake manifold.



2. INSPECT EXHAUST MANIFOLD


A076808E01
  1. Using a precision straightedge and feeler gauge, measure the warpage of the contact surface of the cylinder head.

    Maximum warpage:
    0.7 mm (0.028 in.)

    If the warpage is greater than the maximum, replace the exhaust manifold.

    HINT:
    Maximum warpage of each installation surface:
    0.3 mm (0.012 in.)