OUTER REAR VIEW MIRROR > INSTALLATION |
| 1. INSTALL OUTER MIRROR COVER LH |
Attach the 2 claws as shown in the illustration.

Attach the 6 claws to install the outer mirror cover LH.
![]() |
After installing the outer mirror cover, check that there is no gap between the cover and mirror body.
If there is a gap between the cover and body, noise will occur during driving.
![]() |
Using a T25 "TORX" socket wrench, install the screw.
| *1 | Adhesive |
![]() |
Using a T25 "TORX" socket wrench, install the screws.
| *1 | Adhesive |
Attach the 5 claws.
Install the rubber base with the screw.
![]() |
Apply new tape as shown in the illustration.
| *1 | Tape |
| *a | 40 mm (1.58 in.) |
| 2. INSTALL OUTER MIRROR LH |
![]() |
Attach the 2 claws as shown in the illustration.
![]() |
Attach the 2 clips to install the outer mirror LH.
| 3. INSTALL OUTER REAR VIEW MIRROR ASSEMBLY LH |
![]() |
Install the outer rear view mirror assembly LH with the 3 nuts.
Connect the connector.
| 4. INSTALL FRONT DOOR TRIM BOARD SUB-ASSEMBLY LH |
Attach the 8 clips to install the front door trim board.
Install the screw and clip.
| 5. INSTALL DOOR PULL HANDLE |
Install the door pull handle with the screw.
| 6. INSTALL FRONT DOOR LOWER FRAME BRACKET GARNISH LH |
Attach the 2 clips to install the front door lower frame bracket garnish.
| 7. INSTALL POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL LH (for Driver Side) |
Connect the connector.
Attach the 4 claws and 2 clips to install the power window regulator switch assembly with front door armrest base panel.
| 8. INSTALL POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL RH (for Front Passenger Side) |
Connect the connector.
Attach the 4 claws and 2 clips to install the power window regulator master switch assembly with front door armrest base panel.