Home › STEERING › STEERING COLUMN › STEERING COLUMN ASSEMBLY

STEERING COLUMN ASSEMBLY > REASSEMBLY

for Preparation Click here



1. INSTALL STEERING MAIN SHAFT ASSEMBLY


    G034354E01
  1. Using a snap ring expander, install a new steering main shaft snap ring (inner side) to the steering main shaft.

  1. Install the steering main shaft to the steering column tube.



    G034355E01
  1. Using a snap ring expander, install a steering main shaft snap ring (outer side).



2. INSTALL STEERING MAIN SHAFT BEARING


    C241393E01
  1. Using SST and a hammer, tap in a new bearing.

    SST
    09608-06041  



3. INSTALL KEY INTERLOCK SOLENOID (for Automatic Transmission)


    G034357E01
  1. Install the solenoid to the steering column upper bracket with the 2 screws.



4. INSTALL IGNITION SWITCH ASSEMBLY


    A099992E01
  1. Install the switch to the steering column upper bracket with the 2 claws.



5. INSTALL UNLOCK WARNING SWITCH ASSEMBLY


    G034352E04
  1. Install the switch to the steering column upper bracket with the 2 claws.



6. INSTALL IGNITION SWITCH LOCK CYLINDER ASSEMBLY
  1. Make sure that the lock cylinder is on ACC.

  1. Install the ignition switch lock cylinder.



7. INSPECT STEERING LOCK OPERATION
  1. Check that the steering lock mechanism is activated when the key is removed.

  1. Check that the steering lock mechanism is deactivated when the key is inserted and turned to the ACC position.
    If there is any abnormality, replace the ignition switch lock cylinder assembly.



8. INSTALL STEERING COLUMN UPPER WITH SWITCH BRACKET ASSEMBLY


    G034356E01
  1. Install the steering column upper bracket and steering column upper clamp with 2 new tapered-head bolts.

  1. Tighten the 2 tapered-head bolts until the bolt heads break off.



9. INSTALL KEY CYLINDER LIGHT ASSEMBLY (w/ Key Cylinder Light)


    E226243
  1. Connect the connector.

  1. Push in the key cylinder light assembly in the direction indicated by the arrow in the illustration to install it.



10. INSTALL TRANSPONDER KEY AMPLIFIER (w/ Engine Immobiliser System)


    G034429E01
  1. Align the amplifier with the installation position of the upper bracket.

  1. Push up the amplifier and connect it to the upper bracket.

    NOTICE:
    Do not apply excessive force to the amplifier as it may be damaged.



11. INSTALL NO. 2 STEERING INTERMEDIATE SHAFT SUB-ASSEMBLY


    G036669E05
  1. Align the matchmarks on the steering intermediate shaft and steering link.

  1. Install the steering intermediate shaft to the steering link with the bolt.

    Torque:
    35 N*m{ 35 kgf*cm , 26 ft.*lbf }



12. INSTALL STEERING SLIDING WITH COUPLING YOKE SUB-ASSEMBLY


    G034345E04
  1. Align the matchmarks on the yoke and steering main shaft.

  1. Install the steering yoke with the bolt.

    Torque:
    28 N*m{ 286 kgf*cm , 21 ft.*lbf }