STEERING COLUMN ASSEMBLY > DISASSEMBLY |
| 1. REMOVE STEERING SLIDING WITH COUPLING YOKE SUB-ASSEMBLY |
![]() |
Place matchmarks on the steering main shaft and yoke.
Remove the bolt and yoke.
| 2. REMOVE NO. 2 STEERING INTERMEDIATE SHAFT SUB-ASSEMBLY |
![]() |
Place matchmarks on the intermediate shaft and steering link.
Remove the bolt and intermediate shaft from the steering link.
| 3. INSPECT STEERING COLUMN ASSEMBLY |
![]() |
Measure the length of the steering main shaft.
| 4. REMOVE KEY CYLINDER LIGHT ASSEMBLY (w/ Key Cylinder Light) |
![]() |
Using a screwdriver, detach the claw key cylinder light assembly in the direction indicated by the arrow in the illustration and remove it.
Disconnect the connector.
| 5. REMOVE TRANSPONDER KEY AMPLIFIER (w/ Engine Immobiliser System) |
![]() |
Using a screwdriver, widen the claw hanging onto the upper bracket by approximately 1.0 mm (0.039 in.).
Pull out the transponder key amplifier with the claw open.
| 6. REMOVE STEERING COLUMN UPPER WITH SWITCH BRACKET ASSEMBLY |
![]() |
Using a 3 mm pin punch, mark the center of the 2 tapered-head bolts.
Using a 3 to 4 mm drill bit, drill into the 2 tapered-head bolts.
Using a screw extractor, remove the 2 bolts and bracket.
| 7. REMOVE STEERING COLUMN UPPER CLAMP |
| 8. REMOVE IGNITION SWITCH LOCK CYLINDER ASSEMBLY |
![]() |
Turn the ignition switch lock cylinder to the ACC position.
Push down the stop pin with a screwdriver and pull out the ignition switch lock cylinder.
| 9. REMOVE UNLOCK WARNING SWITCH ASSEMBLY |
![]() |
Detach the 2 claws and remove the switch.
| 10. REMOVE IGNITION SWITCH ASSEMBLY |
![]() |
Detach the 2 claws and remove the switch from the steering column upper bracket.
| 11. REMOVE KEY INTERLOCK SOLENOID (for Automatic Transmission) |
![]() |
Remove the 2 screws and solenoid from the steering column upper bracket.
| 12. REMOVE STEERING MAIN SHAFT ASSEMBLY |
![]() |
Using a snap ring expander, remove the main shaft snap ring (outer side).
![]() |
Using a brass bar and hammer, tap out the steering main shaft and steering main shaft bearing.
![]() |
Using a snap ring expander, remove the steering main shaft snap ring (inner side).