STEERING GEAR > INSTALLATION |
| 1. INSTALL POWER STEERING LINK ASSEMBLY |
![]() |
Install the steering link with the 2 bolts and 2 nuts.
| 2. INSTALL FRONT STABILIZER BAR FRONT |
Install the front stabilizer bar to the vehicle body.
| 3. STABILIZE SUSPENSION |
| 4. CONNECT STEERING GEAR OUTLET RETURN TUBE |
![]() |
Using union nut wrench, connect the outlet return tube.
![]() |
Install the hose with the clip.
| 5. CONNECT PRESSURE FEED TUBE ASSEMBLY |
![]() |
Install the pressure feed tube to the steering link with the bolt.
![]() |
Using union nut wrench, tighten the flare nut and connect the pressure feed tube.
| 6. CONNECT NO. 2 STEERING INTERMEDIATE SHAFT SUB-ASSEMBLY |
Align the matchmarks on the steering intermediate shaft and steering link.
Install the bolt.
| 7. CONNECT STEERING SLIDING YOKE |
![]() |
Align the matchmarks on the steering sliding yoke and steering intermediate shaft, and connect the steering sliding yoke to the steering intermediate shaft.
Install the bolt labeled B.
Tighten the bolt labeled A.
| 8. CONNECT TIE ROD END SUB-ASSEMBLY LH |
Connect the tie rod end to the steering knuckle arm with the nut.
Install a new cotter pin.
| 9. CONNECT TIE ROD END SUB-ASSEMBLY RH |
| 10. INSTALL FRONT SIDE MEMBER TO FRONT SUSPENSION CROSSMEMBER BRACE |
Install the crossmember brace with the 8 bolts.
| 11. INSTALL NO. 1 ENGINE UNDER COVER |
Install the under cover with the 4 bolts.
| 12. INSTALL NO. 2 ENGINE UNDER COVER |
Install the under cover with the 4 bolts.
| 13. INSTALL FRONT WHEEL |
| 14. PLACE FRONT WHEELS FACING STRAIGHT AHEAD |
| 15. INSTALL COMBINATION SWITCH ASSEMBLY WITH SPIRAL CABLE SUB-ASSEMBLY |
![]() |
Using pliers, pinch the clamp and attach the claw to install the combination switch assembly with spiral cable sub-assembly to the steering column assembly.
Connect the connectors to the combination switch assembly with spiral cable sub-assembly.
| 16. INSTALL STEERING COLUMN COVER UPPER |
Attach the claw to install the upper cover.
| 17. INSTALL STEERING COLUMN COVER LOWER |
![]() |
Install the lower cover with the 3 screws.
| 18. INSTALL STEERING WHEEL ASSEMBLY |
![]() |
Align the matchmarks on the steering wheel and main shaft.
Install the steering set nut.
| 19. INSPECT STEERING WHEEL CENTER POINT |
| 20. INSTALL STEERING PAD ASSEMBLY |
![]() |
Support the steering pad with one hand.
Connect the connector to the steering pad.
Connect the horn connector.
Confirm that the groove along the circumference of the "TORX" screw is attached to the screw case and place the steering pad onto the steering wheel.
Using a T30 "TORX" socket wrench, tighten the 2 screws.
| 21. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |
| 22. CHECK SRS WARNING LIGHT |
| 23. ADD POWER STEERING FLUID |
| 24. BLEED AIR FROM POWER STEERING SYSTEM |
| 25. CHECK POWER STEERING FLUID LEVEL IN RESERVOIR |
| 26. CHECK FOR POWER STEERING FLUID LEAKAGE |
| 27. INSPECT AND ADJUST FRONT WHEEL ALIGNMENT |