Home › ENGINE ยท 5L-E › STARTING › GLOW PLUG

GLOW PLUG > INSTALLATION

for Preparation Click here



1. INSTALL GLOW PLUG ASSEMBLY


    A139524
  1. Using a 12 mm deep socket wrench, install the 4 glow plugs.

    Torque:
    13 N*m{ 130 kgf*cm , 10 ft.*lbf }



2. INSTALL NO. 1 GLOW PLUG CONNECTOR
  1. Install the glow plug connector by uniformly tightening the 4 nuts.

    Torque:
    1.0 N*m{ 10 kgf*cm , 9 in.*lbf }

  1. Install the 4 screw grommets.

  1. Connect the glow plug connector wire with the nut.

    Torque:
    8.4 N*m{ 85 kgf*cm , 74 in.*lbf }



3. INSTALL INTAKE PIPE ASSEMBLY


    A118426
  1. Install the intake pipe with the 2 bolts.

    Torque:
    18 N*m{ 184 kgf*cm , 13 ft.*lbf }

  1. Tighten the 2 intake pipe clamps.



4. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL