Home › TRANSMISSION · A750F AUTOMATIC TRANSMISSION › AUTOMATIC TRANSMISSION SYSTEM

AUTOMATIC TRANSMISSION SYSTEM > L4 Position Switch Circuit

for Preparation Click here


DESCRIPTION

The No. 1 transfer indicator switch (L4 position switch) detects the gear position of the transfer shift lever.
Moving the transfer shift lever to L4 turns the L4 position switch ON. Then the ECM cancels operation of the lock-up clutch.

WIRING DIAGRAM


C119181E01


INSPECTION PROCEDURE

1.INSPECT NO. 1 TRANSFER INDICATOR SWITCH (L4 POSITION SWITCH)
A110992E03
  1. Remove the transfer indicator switch.

  1. Measure the resistance of the switch when pushing the ball at the tip of the switch.

    Tester Connection
    Switch Condition
    Specified Condition
    1 - 2
    Not pushed
    10 kΩ or higher
    1 - 2
    Pushed
    Below 1 Ω



NG
REPLACE NO. 1 TRANSFER INDICATOR SWITCH (L4 POSITION SWITCH)
OK


2.CHECK WIRE HARNESS (NO. 1 TRANSFER INDICATOR SWITCH - ECM AND BODY GROUND)
A107755E03
  1. Disconnect the T5 switch connector.

  1. Disconnect the E17 ECM connector.

  1. Measure the resistance of the wire harness side connectors.

    Standard resistance:
    Tester Connection
    Specified Condition
    E17-13 (L4) - T5-1 (L4)
    Below 1 Ω
    T5-2 (L4) - Body ground
    Below 1 Ω
    E17-13 (L4) - Body ground
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS AND CONNECTOR
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE