Home › TRANSMISSION · A340F AUTOMATIC TRANSMISSION › AUTOMATIC TRANSMISSION SYSTEM

AUTOMATIC TRANSMISSION SYSTEM > L4 Position Switch Circuit

for Preparation Click here


DESCRIPTION

The No. 1 transfer indicator switch (L4 position switch) detects the gear position of the transfer shift lever.
Moving the transfer shift lever to L4 turns the L4 position switch ON. Then the TCM cancels operation of the lock-up clutch.

WIRING DIAGRAM


C154998E41


INSPECTION PROCEDURE

1.CHECK HARNESS AND CONNECTOR (NO. 1 TRANSFER INDICATOR SWITCH - BODY GROUND)
C155110E06
  1. Disconnect the T5 switch connector.

  1. Measure the resistance of the wire harness side connector.

    Standard resistance:
    Tester Connection
    Specified Condition
    T5-2 - Body ground
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


2.INSPECT NO. 1 TRANSFER INDICATOR SWITCH (L4 POSITION SWITCH)
A110992E20
  1. Remove the transfer indicator switch.

  1. Measure the resistance of the switch when pushing the ball at the tip of the switch.

    Standard resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    1 - 2
    Not pushed
    10 kΩ or higher
    1 - 2
    Pushed
    Below 1 Ω



NG
REPLACE NO. 1 TRANSFER INDICATOR SWITCH (L4 POSITION SWITCH)
OK


3.CHECK WIRE HARNESS (NO. 1 TRANSFER INDICATOR SWITCH - TCM AND BODY GROUND)
C154992E06
  1. Disconnect the T5 switch connector.

  1. Disconnect the T38 TCM connector.

  1. Measure the resistance of the wire harness side connectors.

    Standard resistance:
    Tester Connection
    Specified Condition
    T5-1 - T38-15 (L4)
    Below 1 Ω
    T38-15 (L4) - Body ground
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS AND CONNECTOR
OK

REPLACE TCM