Home › ENGINE ยท 1KD-FTV › STARTING › STARTER (for DENSO Made)

STARTER (for DENSO Made) > DISASSEMBLY

for Preparation Click here



1. REMOVE STARTER YOKE ASSEMBLY


    P013020
  1. Remove the nut and disconnect the lead wire from terminal C.



    A074859
  1. Remove the 2 bolts and 2 O-rings.

  1. Pull out the starter yoke with the armature.

  1. Remove the O-ring from the starter yoke.



2. REMOVE MAGNET STARTER SWITCH ASSEMBLY


    A102596
  1. Remove the 2 screws and magnet starter switch assembly.

  1. Remove the return spring.



  1. Remove the pinion gear, idler gear, clutch roller, retainer and starter clutch assembly from the starter drive housing.


    A121405E03



    A115020E02
  1. Using a magnet hand, remove the steel ball from the clutch shaft hole.



    A204323
  1. Remove the O-ring from the starter drive end housing.



3. REMOVE STARTER BRUSH HOLDER ASSEMBLY


    N000562
  1. Disconnect the 4 starter yoke brushes from the brush holder.

    1. Using a screwdriver, pull back the spring.

    2. Disconnect the brush from the brush holder.

  1. Remove the brush holder from the starter yoke.



4. REMOVE STARTER ARMATURE ASSEMBLY


    P005488
  1. Using a plastic-faced hammer, tap the end of the starter yoke to remove the starter armature from the starter yoke.