STARTER (for DENSO Made) > REASSEMBLY |
| 1. INSTALL MAGNET STARTER SWITCH ASSEMBLY |
![]() |
Install a new O-ring to the groove of the starter drive end housing.
Apply high-temperature grease to the idler gear, pinion gear, steel ball, return spring, clutch roller and retainer.
![]() |
Install the steel ball.
Insert the return spring into the starter clutch hole.
Install the starter clutch, pinion gear, idler gear, retainer and clutch roller to the starter drive housing.

![]() |
Install the starter drive housing to the magnet starter switch assembly with the 2 screws.
| 2. INSTALL STARTER ARMATURE ASSEMBLY |
Apply high-temperature grease to the starter armature bearing.
![]() |
Using a press, press the starter armature into the starter yoke assembly to install it.
| 3. INSTALL STARTER BRUSH HOLDER ASSEMBLY |
![]() |
Align the claw of the brush holder with the claw groove of the starter yoke assembly.
Install the brush holder to the starter yoke assembly.
![]() |
Install the 4 starter yoke brushes to the brush holder.
Using a screwdriver, pull back the spring.
Install the brush to the brush holder.
| 4. INSTALL STARTER YOKE ASSEMBLY |
![]() |
Install a new O-ring to the groove of the starter yoke assembly.
![]() |
Align the punch mark of the starter yoke assembly with the line of the magnet starter switch assembly and install the starter yoke assembly.
![]() |
Install 2 new O-rings to the bolts.
Install the 2 bolts.
![]() |
Connect the lead wire to terminal C with the nut.