DTC P0717 Input Speed Sensor Circuit No Signal |

| DTC No. | DTC Detection Condition | Trouble Area |
| P0717 | All conditions below are detected for 5 sec. or more (1 trip detection logic): (a) Gear changes not performed (b) Gear position: 4th or 5th (c) Transmission input shaft rpm: less than 300 rpm (d) Transmission output shaft rpm: 1,000 rpm or more (e) Park/Neutral position switch
|
|

| Item | Measurement Item/ Range (Display) | Normal Condition | Diagnostic Note |
| SPD (NT) | Input turbine speed/ Min.: 0 rpm Max.: 12,750 rpm |
| Data is displayed in increments of 50 rpm |
| 1.INSPECT SPEED SENSOR (INSTALLATION) |
![]() |
Check the speed sensor NT installation.
|
| ||||
| OK | |
| 2.INSPECT INPUT SPEED SENSOR NT |
![]() |
Disconnect the T27 sensor connector from the transmission.
Measure the resistance of the sensor.
| Tester Connection | Condition | Specified Condition |
| 1 - 2 | 20°C (68°F) | 560 to 680 Ω |
![]() |
| Item | Content |
| Tester Connection | E16-35 (NT+) - E16-27 (NT-) |
| Tool Setting | 1 V/DIV., 2 msec./DIV. |
| Condition | Engine is idling (P or N position) |
|
| ||||
| OK | |
| 3.CHECK WIRE HARNESS (INPUT SPEED SENSOR - ECM) |
![]() |
Disconnect the E16 ECM connector.
Measure the resistance of the wire harness side connector.
| Tester Connection | Condition | Specified Condition |
| E16-35 (NT+) - E16-27 (NT-) | 20°C (68°F) | 560 to 680 Ω |
| E16-35 (NT+) - Body ground | 20°C (68°F) | 10 kΩ or higher |
| E16-27 (NT-) - Body ground | 20°C (68°F) | 10 kΩ or higher |
|
| ||||
| OK | ||
| ||