BACK DOOR GLASS > REMOVAL |
| 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
| 2. REMOVE REAR WIPER ARM ASSEMBLY |
![]() |
Open the wiper arm head cap..
![]() |
Remove the nut and the arm and blade.
| 3. REMOVE REAR SPOILER |
![]() |
Remove the 2 grommets.
![]() |
Remove the 3 nuts.
![]() |
Put protective tape around the rear spoiler.
| *1 | Protective Tape |
Detach the 4 clips and remove the rear spoiler.
| 4. REMOVE BACK DOOR GLASS CHANNEL LH |
![]() |
Using a clip remover, remove the 2 clips.
Using a screwdriver, detach the tape and remove the channel.
| 5. REMOVE BACK DOOR GLASS CHANNEL RH |
| 6. REMOVE BACK DOOR TRIM BOARD ASSEMBLY |
![]() |
Detach the 16 clips and remove the back door trim board.
| 7. REMOVE BACK DOOR GLASS |
Disconnect the rear window defogger connector.
![]() |
Apply protective tape to the outer surface of the vehicle body to prevent scratches.
![]() |
From the interior, insert a piano wire between the vehicle body and back door glass as shown in the illustration.
Tie objects that can serve as handles (for example, wooden blocks) to both wire ends.
Cut through the adhesive by pulling the piano wire around the back door glass.
Using suction cups, remove the back door glass.
| 8. REMOVE BACK WINDOW OPENING TRIM |
Remove the back window opening trim.
| 9. CLEAN BACK DOOR GLASS |
![]() |
Clean the outer edge of the back door glass with non-residue solvent.
| 10. CLEAN VEHICLE BODY |
![]() |
Using a scraper, remove the moulding and adhesive from the back door glass.
Clean and shape the contact surface of the vehicle body.
On the contact surface of the vehicle body, use a knife to cut away excess adhesive as shown in the illustration.
Clean the contact surface of the vehicle body with cleaner.