QUARTER WINDOW GLASS > REMOVAL |
| 1. REMOVE REAR SEAT FRONT BRACKET COVER RH |
![]() |
Fully tilt the seatback forward.
Remove the screw.
Pull the bracket cover in the direction indicated by the arrow in the illustration to detach the claw and remove the bracket cover.
| 2. REMOVE REAR SEAT REAR BRACKET COVER RH |
| 3. REMOVE REAR NO. 2 SEAT ASSEMBLY RH |
![]() |
Remove the 2 bolts.
Unlock the seat legs by horizontally pulling the release band. Then remove the seat.
| 4. REMOVE BACK DOOR SCUFF PLATE |
![]() |
Detach the 4 claws, 2 guides and 6 clips and remove the back door scuff plate.
| 5. REMOVE REAR DOOR SCUFF PLATE RH |
| 6. REMOVE REAR DOOR OPENING TRIM WEATHERSTRIP RH |
| 7. DISCONNECT REAR NO. 1 OUTER SEAT BELT ASSEMBLY OUTER RH |
Partially remove the rear No. 1 seat belt outer RH.
| 8. DISCONNECT REAR NO. 2 OUTER SEAT BELT ASSEMBLY OUTER RH |
Partially remove the rear No. 2 seat belt outer RH.
| 9. REMOVE QUARTER INSIDE TRIM BOARD RH |
![]() |
Detach the 2 claws and remove the outer lap belt anchor cover.
![]() |
Remove the bolt and disconnect the rear No. 1 seat outer belt floor anchor.
![]() |
Remove the bolt and disconnect the rear No. 2 seat outer belt floor anchor.
Using a clip remover, remove the clip.
Detach the 8 claws and 10 clips and remove the quarter inside trim board.

| 10. REMOVE QUARTER PILLAR GARNISH RH |
| 11. REMOVE INNER UPPER ROOF SIDE GARNISH RH |
| 12. REMOVE ASSIST GRIP |
![]() |
Using a screwdriver, detach the 4 claws and open the 2 covers.
| *1 | Protective Tape |
![]() |
Remove the 2 screws and assist grip.
| 13. REMOVE NO. 1 ROOM LIGHT ASSEMBLY |
![]() |
Using a screwdriver wrapped with protective tape, detach the 4 claws and remove the lens.
![]() |
Remove the 2 screws and room light.
Disconnect the light connector.
| 14. REMOVE ROOF HEADLINING ASSEMBLY |
Partially remove the roof headlining .
| 15. REMOVE QUARTER WINDOW ASSEMBLY RH |
![]() |
Using a knife, cut off the moulding as shown in the illustration.
Remove the remaining moulding.
Disconnect the connector.
![]() |
From the interior, insert a piano wire between the vehicle body and the quarter window glass as shown in the illustration.
Tie objects that can serve as handles (for example, wooden blocks) to both wire ends.
Cut through the adhesive by pulling the piano wire around the quarter window glass.
Using suction cups, remove the quarter window glass.
| 16. REMOVE QUARTER WINDOW GLASS SPACER |
![]() |
Remove the spacer from the vehicle body.
| 17. CLEAN QUARTER WINDOW ASSEMBLY |
![]() |
Clean the outer edges of the glass with non-residue solvent.
| 18. CLEAN VEHICLE BODY |
![]() |
Clean and shape the contact surface of the vehicle body.
On the contact surface of the vehicle body, use a knife to cut away excess adhesive as shown in the illustration.
Clean the contact surface of the vehicle body with cleaner.