POWER WINDOW CONTROL SYSTEM > INITIALIZATION |
| RESET (INITIALIZE) THE FRONT DOOR WINDOW REGULATOR SUB-ASSEMBLY (for Driver Side) |
Turn the ignition switch to ON.
Open the power window halfway by pressing the power window regulator master switch assembly.
Fully pull up on the switch until the power window is fully closed and continue to hold the switch for at least 1 second.
Check that the auto up/down function operates normally.
If the auto up/down function operates normally, reset operations are completed. If abnormal, follow the 3 steps below.
Disconnect the cable from the negative (-) battery terminal for 10 seconds.
Connect the cable to the negative (-) battery terminal.
Perform the first 4 steps again.
If the auto up/down function operates normally, reset operations have been completed at this time. If abnormal, follow the 4 steps below.
Turn the ignition switch to ON.
Open the power window halfway by pressing the power window regulator master switch assembly.
Fully pull up on the switch until the power window is fully closed and continue to hold the switch for approximately 12 seconds after the power window is fully closed.
Check that the auto up/down function operates normally.