DTC 23 Pressure Switch Circuit |

| DTC Code | DTC Detection Condition | Trouble Area |
| 23 | When either condition below is met:
|
|

| 1.CHECK REFRIGERANT PRESSURE |
Install a manifold gauge.
Check refrigerant pressure (Click here).
|
| ||||
| OK | |
| 2.CHECK AIR CONDITIONING OPERATION |
![]() |
Disconnect the P2 air conditioner pressure sensor connector.
Using a service wire, connect terminals 1 and 2 of the connector on the vehicle wire harness side.
Start the engine.
Turn the A/C switch on and check the magnet clutch.
| *a | Front view of wire harness connector (to Air Conditioner Pressure Sensor) |
|
| ||||
| OK | ||
| ||
| 3.CHECK HARNESS AND CONNECTOR (AIR CONDITIONER PRESSURE SENSOR - AIR CONDITIONING AMPLIFIER AND BODY GROUND) |
Disconnect the P2 air conditioner pressure sensor connector.
Disconnect the A37 air conditioning amplifier assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| P2-2 - A37-5 (PSW) | Always | Below 1 Ω |
| P2-1 - Body ground | ||
| P2-2 - Body ground | Always | 10 kΩ or higher |
| Result | Proceed to |
| OK (When troubleshooting according to problem symptoms table.) | A |
| OK (When troubleshooting according to DTC.) | B |
| NG | C |
|
| ||||
|
| ||||
| A | ||
| ||