DTC 43 Air Outlet Damper Control Servo Motor Circuit |
| DTC Code | Detection Item | Trouble Area |
| 43 | The mode damper position does not change when the air conditioning amplifier assembly operates the mode damper servo sub-assembly. |
|

| 1.PERFORM ACTUATOR CHECK |
Warm up the engine.
Enter actuator check mode (Click here).
Place your hand in front of a vent and check that the mode damper position changes according to the display code.
| Display Code | Mode Damper Position |
| 0 | FACE |
| 1 | FACE |
| 2 | FACE |
| 3 | FACE |
| 4 | FACE |
| 5 | BI-LEVEL |
| 6 | FOOT |
| 7 | FOOT |
| 8 | FOOT/DEF |
| 9 | DEF |
| Result | Proceed to |
| OK (When troubleshooting according to problem symptoms table.) | A |
| OK (When troubleshooting according to DTC.) | B |
| NG | C |
|
| ||||
|
| ||||
| A | ||
| ||
| 2.CHECK HARNESS AND CONNECTOR (MODE DAMPER SERVO - AIR CONDITIONING AMPLIFIER) |
Disconnect the D2 mode damper servo sub-assembly connector.
Disconnect the A38 and A37 air conditioning amplifier assembly connectors.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| D2-4 - A38-4 (AOD) | Always | Below 1 Ω |
| D2-5 - A38-3 (AOF) | ||
| D2-2 - A37-26 (POA) | ||
| D2-3 - A37-25 (POB) | ||
| D2-1 - A37-11 (SG-2) | ||
| D2-4 - Body ground | Always | 10 kΩ or higher |
| D2-5 - Body ground | ||
| D2-2 - Body ground | ||
| D2-3 - Body ground | ||
| D2-1 - Body ground |
|
| ||||
| OK | |
| 3.REPLACE MODE DAMPER SERVO SUB-ASSEMBLY |
Temporally replace the mode damper servo sub-assembly with a new or normally functioning one (Click here).
Check the mode damper operates normally.
|
| ||||
| OK | ||
| ||