POWER WINDOW CONTROL SYSTEM > Driver Side Power Window Manual Function does not Operate with Power Window Master Switch |

| 1.CHECK HARNESS AND CONNECTOR (POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY - BATTERY AND BODY GROUND) |
![]() |
Disconnect the P6 power window regulator master switch assembly connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| P6-7 (BW) - Body ground | Always | 11 to 14 V |
| P6-6 (B) - Body ground | Ignition switch ON | 11 to 14 V |
| Ignition switch off | Below 1 V |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| P6-1 (E) - Body ground | Always | Below 1 Ω |
| *a | Front view of wire harness connector (to Power Window Regulator Master Switch Assembly) |
|
| ||||
| OK | |
| 2.CHECK FRONT DOOR WINDOW REGULATOR SUB-ASSEMBLY (FOR DRIVER SIDE) |
![]() |
Disconnect the P6 power window regulator master switch assembly connector.
Check operation of the front door window regulator sub-assembly (for driver side).
| Tester Connection | Condition | Specified Condition |
| P6-4 (U) - P6-7 (BW) P6-9 (D) - Body ground | Always | Power window moves up |
| P6-4 (U) - Body ground P6-7 (BW) - P6-9 (D) | Always | Power window moves down |
| *a | Front view of wire harness connector (to Power Window Regulator Master Switch Assembly) |
|
| ||||
| OK | ||
| ||
| 3.CHECK HARNESS AND CONNECTOR (POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY - FRONT DOOR WINDOW REGULATOR SUB-ASSEMBLY [FOR DRIVER SIDE]) |
Disconnect the P6 power window regulator master switch assembly connector.
Disconnect the P7*1 or P8*2 front door window regulator sub-assembly (for driver side) connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| P6-9 (D) - P7-1 | Always | Below 1 Ω |
| P6-4 (U) - P7-2 | Always | Below 1 Ω |
| P6-9 (D) or P7-1 - Body ground | Always | 10 kΩ or higher |
| P6-4 (U) or P7-2 - Body ground | Always | 10 kΩ or higher |
| Tester Connection | Condition | Specified Condition |
| P6-9 (D) - P8-1 | Always | Below 1 Ω |
| P6-4 (U) - P8-2 | Always | Below 1 Ω |
| P6-9 (D) or P8-1 - Body ground | Always | 10 kΩ or higher |
| P6-4 (U) or P8-2 - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | ||
| ||