Home › RESTRAINTS › SEAT BELT › REAR SEAT OUTER BELT ASSEMBLY

REAR SEAT OUTER BELT ASSEMBLY > REMOVAL

for Preparation Click here


HINT:
  1. Use the same procedures for the RH side and LH side.
  2. The procedures listed below are for the RH side.



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.



2. REMOVE REAR NO. 2 SEAT ASSEMBLY RH


B089761E01
  1. Remove the 2 bolts.

  1. Unlock the seat legs by horizontally pulling the release band. Then remove the seat.

    NOTICE:
    Be careful not to damage the vehicle body,



3. REMOVE BACK DOOR SCUFF PLATE


B276933
  1. Detach the 4 claws, 2 guides and 6 clips and remove the back door scuff plate.



4. REMOVE REAR DOOR SCUFF PLATE RH

HINT:
Use the same procedure described for the LH side.



5. REMOVE REAR DOOR OPENING TRIM WEATHERSTRIP RH

HINT:
Use the same procedure described for the LH side.



6. REMOVE QUARTER TRIM HOOK


B276937

HINT:
Use the same procedure for both quarter trim hooks.

  1. Remove the screw and quarter trim hook.



7. DISCONNECT REAR NO. 1 SEAT BELT ASSEMBLY OUTER RH


B121286
  1. Detach the 2 claws and remove the lap belt outer anchor cover.

  1. Remove the bolt and disconnect the seat belt.



8. DISCONNECT REAR NO. 2 SEAT BELT ASSEMBLY OUTER RH


B121287
  1. Disconnect the rear No. 2 seat belt outer anchor.

    1. Detach the 2 claws and remove the lap belt outer anchor cover.

    2. Remove the bolt and disconnect the seat belt.



9. REMOVE QUARTER INSIDE TRIM BOARD RH


B276928
  1. Detach the 2 claws and remove the outer lap belt anchor cover.

    HINT:
    Use the same procedure for both outer lap belt anchor covers.



    B277804
  1. Remove the bolt and disconnect the rear No. 1 seat outer belt floor anchor.



    B277805
  1. Remove the bolt and disconnect the rear No. 2 seat outer belt floor anchor.

  1. Using a clip remover, remove the clip.



  1. Detach the 8 claws and 10 clips and remove the quarter inside trim board.


    B276941



10. REMOVE REAR NO. 1 SEAT BELT ASSEMBLY OUTER RH


B086292E05
  1. Using a screwdriver, detach the 2 claws and open the seat belt anchor cover as shown in the illustration.

    HINT:
    Tape the screwdriver tip before use.

  1. Remove the bolt and disconnect the seat belt's shoulder anchor.



    B089851E01
  1. Remove the bolt and seat belt.



11. REMOVE REAR NO. 2 SEAT BELT ASSEMBLY OUTER LH


B086292E05
  1. Using a screwdriver, detach the 2 claws and open the seat belt anchor cover as shown in the illustration.

    HINT:
    Tape the screwdriver tip before use.

  1. Remove the bolt and disconnect the seat belt's shoulder anchor.



    B089928E01
  1. Remove the bolt and seat belt.