Home › RESTRAINTS › SEAT BELT › REAR SEAT OUTER BELT ASSEMBLY

REAR SEAT OUTER BELT ASSEMBLY > REMOVAL

for Preparation Click here


HINT:
  1. Use the same procedures for the RH side and LH side.
  2. The procedures listed below are for the RH side.



1. PRECAUTION

NOTICE:
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (Click here).



2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).



3. REMOVE REAR NO. 2 SEAT ASSEMBLY RH


B089761E01
  1. Remove the 2 bolts.

  1. Unlock the seat legs by horizontally pulling the release band. Then remove the seat.

    NOTICE:
    Be careful not to damage the vehicle body,



4. REMOVE BACK DOOR SCUFF PLATE


B276933
  1. Detach the 4 claws, 2 guides and 6 clips and remove the back door scuff plate.



5. REMOVE REAR DOOR SCUFF PLATE RH

HINT:
Use the same procedure described for the LH side.



6. REMOVE REAR DOOR OPENING TRIM WEATHERSTRIP RH

HINT:
Use the same procedure described for the LH side.



7. REMOVE QUARTER TRIM HOOK


B276937

HINT:
Use the same procedure for both quarter trim hooks.

  1. Remove the screw and quarter trim hook.



8. DISCONNECT REAR NO. 1 SEAT BELT ASSEMBLY OUTER RH


B121286
  1. Detach the 2 claws and remove the lap belt outer anchor cover.

  1. Remove the bolt and disconnect the seat belt.



9. DISCONNECT REAR NO. 2 SEAT BELT ASSEMBLY OUTER RH


B121287
  1. Disconnect the rear No. 2 seat belt outer anchor.

    1. Detach the 2 claws and remove the lap belt outer anchor cover.

    2. Remove the bolt and disconnect the seat belt.



10. REMOVE QUARTER INSIDE TRIM BOARD RH


B276928
  1. Detach the 2 claws and remove the outer lap belt anchor cover.

    HINT:
    Use the same procedure for both outer lap belt anchor covers.



    B277804
  1. Remove the bolt and disconnect the rear No. 1 seat outer belt floor anchor.



    B277805
  1. Remove the bolt and disconnect the rear No. 2 seat outer belt floor anchor.

  1. Using a clip remover, remove the clip.



  1. Detach the 8 claws and 10 clips and remove the quarter inside trim board.


    B276941



11. REMOVE REAR NO. 1 SEAT BELT ASSEMBLY OUTER RH


B086292E05
  1. Using a screwdriver, detach the 2 claws and open the seat belt anchor cover as shown in the illustration.

    HINT:
    Tape the screwdriver tip before use.

  1. Remove the bolt and disconnect the seat belt's shoulder anchor.



    B089851E01
  1. Remove the bolt and seat belt.



12. REMOVE REAR NO. 2 SEAT BELT ASSEMBLY OUTER LH


B086292E05
  1. Using a screwdriver, detach the 2 claws and open the seat belt anchor cover as shown in the illustration.

    HINT:
    Tape the screwdriver tip before use.

  1. Remove the bolt and disconnect the seat belt's shoulder anchor.



    B089928E01
  1. Remove the bolt and seat belt.